Carbide burr, red cone, Staleks Pro Expert 6/14 mm

Staleks Pro Expert 6/14mm red cone carbide burr

Carbide burr for manicure/pedicure machines. Red cut with soft grain, means delicate cross-cut (the hardness of the burr depends on the number and depth of the blades).

"Cone" shape for correcting artificial nails, removing gel polish and hard coatings. It is important to observe the recommended speed, as excessive speed may injure the client.

In manicure:

• Correction of artificial nails.
• Preparation of artificial nails for extension.
• Correction of the nail plate.
• Carefully trims the material and leaves a smooth surface.
• During work, it removes material in the form of fine chips rather than dust.

In pedicure/podiatry:

• Working on calloused areas of skin.
• Treatment of calluses and corns.
• High-quality metal.
• Suitable for all types of sterilization and disinfection.
• Corrosion resistant.

Features:

• High-quality diamond coating.
• Suitable for all types of sterilization and disinfection.
• Corrosion resistant.

Characteristics:

• Diameter: 6 mm
• Working part: 14 mm

Instructions for use:

1. Install the nail drill bit according to the device instructions.
2. Use it to remove artificial coatings from the nail plate, shape and correct artificial nails, remove excess material, prepare natural nails for reapplication of the coating, and polish rough skin around the nail plate.
3. Then remove the cutter from the device.

Warnings:

• Store in a dry, ventilated place, out of the reach of children, at least 1 m away from heating devices, at a temperature not lower than +0°C and not higher than +40°C, and at a relative humidity of up to 80%.
• Use as intended, keep clean and dry after use.
• Do not use acids or alkalis for disinfection and sterilization.
• Do not use abrasive or metal objects for cleaning.
• Do not allow to fall onto hard surfaces and avoid contact with corrosive contaminants.
• Resistant to all types of disinfection and sterilization without loss of quality.